Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SNMP Modules - defining values for Warning and Critical
#1
Using software agents, I have created SNMP modules for checking the state of DELL RAID Virtual Disks and Physical Disks in the VD.
Basically, my problem is this:

The normal value for an online physical [member] disk is 3 (online), anything else should create an event and, then, an alert; as with hot-spares, that should normally return 1 (ready).

Can anyone explain how I can configure warning and critical status values so events get created so I can, then, receive alerts?

Any help will be very much appreciated.
 Reply
Messages In This Thread
SNMP Modules - defining values for Warning and Critical - by mjohnson - 10-31-2014, 09:46 PM


Users browsing this thread: 1 Guest(s)


(c) 2006-2018 Artica Soluciones Tecnológicas. Contents of this wiki are under Create Common Attribution v3 licence. | pandorafms.com | pandorafms.org

Theme © MyBB Themes