Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Host alive configuration
#1
Hi everyone,

I'd like to configure warning and critical condition for host alive module.
I don't know if it's seconds or percentage.
Thanks in advance for your help.

Have a nice day !
 Reply
#2
Good morning

The alive host modules report boolean data that is not measured either in percentage or time simply the device is on or off (0-1) so you have to set warning or critical depending on the severity you estimate for a system that is off or on.

Regards
 Reply


Users browsing this thread: 1 Guest(s)


(c) 2006-2018 Artica Soluciones Tecnológicas. Contents of this wiki are under Create Common Attribution v3 licence. | pandorafms.com | pandorafms.org

Theme © MyBB Themes